10.3 Hydraulic Systems
Clasification Society 2024 - Version 9.40
Statutory Documents - IMO Publications and Documents - International Codes - DSC Code - Code of Safety for Dynamically Supported Craft – Resolution A.373(X) - Chapter 10 - Auxiliary Systems - 10.3 Hydraulic Systems

10.3 Hydraulic Systems

  10.3.1 In addition to the requirements in 10.1.3, the additional pressure due to hydraulic shock and the rate of pressure rise caused by hydraulic shock should be considered in the design of hydraulic piping systems.

  10.3.2 The Administration should be satisfied with the hydraulic fluid used and the procedure for installation testing.

Parent topic: Chapter 10 - Auxiliary Systems
Copyright 2022 Clasifications Register Group Limited, International Maritime Organization, International Labour Organization or Maritime and Coastguard Agency. All rights reserved. Clasifications Register Group Limited, its affiliates and subsidiaries and their respective officers, employees or agents are, individually and collectively, referred to in this clause as 'Clasifications Register'. Clasifications Register assumes no responsibility and shall not be liable to any person for any loss, damage or expense caused by reliance on the information or advice in this document or howsoever provided, unless that person has signed a contract with the relevant Clasifications Register entity for the provision of this information or advice and in that case any responsibility or liability is exclusively on the terms and conditions set out in that contract.