Description
Ferrosilicon is an extremely heavy cargo.
Characteristics
Physical properties
|
Size
|
Angle of repose
|
Bulk density
(kg/m3)
|
Stowage factor
(m3/t)
|
Up to 300 mm
briquettes
|
Not applicable
|
1,389 to 2,083 (1,111
to 1,538 for briquettes)
|
0.48 to 0.72 (0.65 to
0.90 for briquettes)
|
Hazard
classification
|
Class
|
Subsidiary hazard(s)
|
MHB
|
Group
|
4.3
|
6.1
|
|
B
|
Hazard
In contact with moisture or water it may evolve hydrogen, a flammable gas
which may form explosive mixtures with air and may, under similar circumstances, produce
phosphine and arsine, which are highly toxic gases.
This cargo is non-combustible or has a low fire risk.
Stowage and segregation
"Separated from" foodstuffs and all class 8 liquids.
Hold cleanliness
Clean and dry as relevant to the hazards of the cargo.
Weather precautions
This cargo shall be kept as dry as practicable before loading, during
loading and during voyage. This cargo shall not be loaded during precipitation. During
loading of this cargo, all non-working hatches of the cargo spaces to which this cargo
is loaded, or to be loaded, shall be closed.
Loading
Trim in accordance with the relevant provisions required under sections 4
and 5 of this Code.
When the stowage factor of this cargo is equal to or less than 0.56 m3/t, the
tank top may be overstressed unless the cargo is evenly spread across the tank top to
equalize the weight distribution. Due consideration shall be given to ensure that the
tank top is not overstressed during the voyage and during loading by a pile of the
cargo. Refer to the appendix to this schedule.
Precautions
The manufacturer or the shipper shall provide the master with a certificate
stating that, after manufacture, the cargo was stored under cover, but exposed to dry
weather for not less than three days prior to shipment.
Ventilation
Continuous mechanical ventilation shall be conducted during the voyage for
the cargo spaces carrying this cargo. If maintaining ventilation endangers the ship or
the cargo, it may be interrupted unless there is a risk of explosion or other danger due
to interruption of the ventilation. In any case, mechanical ventilation shall be
maintained for a reasonable period prior to discharge. Refer to the appendix to this
schedule.
Carriage
For quantitative measurements of hydrogen, phosphine and arsine, suitable
detectors for each gas or combination of gases shall be on board while this cargo is
carried. The detectors shall be of certified safe type for use in explosive atmosphere.
The concentrations of these gases in the cargo spaces carrying this cargo shall be
measured regularly, during the voyage, and the results of the measurements shall be
recorded and kept on board.
Discharge
Refer to the appendix to this schedule.
Clean-up
After discharge of this cargo, the cargo spaces shall be swept clean twice.
Water shall not be used for cleaning of the cargo space which has contained
this cargo, because of danger of gas.
Emergency procedures
Special emergency equipment to
be carried
|
Self-contained breathing
apparatus.
|
Emergency
procedures
|
Wear self-contained breathing
apparatus.
|
Emergency action in the event
of fire
|
Batten down and use
CO2, if available. Do not use water.
|
Medical first aid
|
Refer to the Medical First Aid
Guide (MFAG), as amended.
|
APPENDIX - GENERAL REQUIREMENTS FOR CARRIAGE OF FERROSILICON
1 Chapter II-2 of SOLAS requires fire-fighter's outfits, full chemical
protective suits and self-contained breathing apparatus to be readily available on
board.
2 Gas concentrations shall be measured, during the voyage, at least once during every
eight hours at each outlet ventilator and in any other accessible space adjacent to the
cargo space carrying this cargo and the results shall be recorded in the logbook.
Facilities shall be provided to make accurate determinations of the gas concentrations
at each outlet ventilator without danger to the operator.
3 Ventilation fans shall be in operation at all times from commencement of loading until
the cargo space is free of ferrosilicon.
4 The bilge wells shall be in a clean, dry condition before loading. The bilge timbers
shall be in good condition and covered with double burlap.
5 The bilge wells shall be opened up and the cargo space cleaned up after discharging. A
gas check shall be made before commencement of cleaning up.
DETAILED REQUIREMENTS
Prior to loading, the bulkheads to the engine-room shall be inspected and
approved by the Administration as gastight and the safety of the bilge pumping
arrangements shall be approved by the Administration. Inadvertent pumping through
machinery spaces shall be avoided.
-
(i) Where the bilge suction valve of the cargo space is located in the machinery
space, the valve shall be checked and the valve lid and seat lapped to a fine
finish, as necessary. After re-assembly, the valve shall be locked shut and a
notice shall be placed adjacent to the valve warning against opening without the
master's permission.
-
(ii) All pipes passing through the cargo space shall be in good order and
condition. Hold atmosphere sampling units shall be effectively blanked off.
-
(iii) Electrical circuits for equipment in cargo spaces which is unsuitable for
use in an explosive atmosphere shall be isolated by removal of links in the system
other than fuses.
-
(iv) The cargo spaces shall be ventilated by at least two separate fans which
shall be explosion-proof and arranged so that the escaping gas flow is separated
from electrical cables and components. The total ventilation shall be at least 6
air changes per hour, based on an empty cargo space.
-
(v) Ventilator trunkings shall be in sound condition and so arranged to preclude
interconnection of the atmosphere in the cargo space with other cargo spaces,
accommodation or work areas.
OPERATIONAL
REQUIREMENTS
-
(i) Smoking and naked flame shall be prohibited on deck in the vicinity of the
cargo space or in the cargo space itself during loading or discharging.
-
(ii) Any portable lighting shall be safe for use in an explosive atmosphere.
-
(iii) The cargo shall be kept dry and, during wet weather conditions, cargo
handling shall be suspended and the cargo space shall be closed.
-
(iv) Sets of self-contained breathing apparatus shall be located and stored for
immediate use together with a lifeline and a gas detector.
-
(v) Prior to commencement of discharging, the atmosphere in the cargo space shall
be tested for the presence of toxic and flammable gases.
-
(vi) Checks for contaminant gases shall be carried out at 30-min intervals while
persons are in the cargo space.
-
(vii) Entry into the cargo space shall be prohibited when gas
concentrations exceed the Threshold Limit Values for phosphine (0.3 ppm) or for
arsine (0.05 ppm) or where the oxygen level is below 18%.footnote
GASES RELEASED FROM FERROSILICON
IMPURITIES WHEN WATER IS ADDED
(i) Arsine
Arsine is a toxic, colourless gas with a garlic-like odour.
Toxicity
Arsine is a nerve and blood poison. There is generally a delay before the onset of
symptoms (sometimes a day or so). These are at first indefinite.
Symptoms
1 Feeling of malaise, difficulty in breathing, severe headache, giddiness, fainting
fits, nausea, vomiting and gastric disturbances.
2 In severe cases, vomiting may be pronounced, the mucous membranes may have a bluish
discolouration and urine is dark and bloodstained. After a day or so there is severe
anaemia and jaundice.
Concentration
A concentration of 500 ppm is lethal to humans after exposure of a few minutes, while
concentrations of 250 ppm are dangerous to life after 30 min exposure. Concentrations of
6.25 to 15.5 ppm are dangerous after exposure of 30 to 60 min. A concentration of 0.05
ppm is the threshold long limit to which a person may be exposed.
(ii) Phosphine
Phosphine is colourless, flammable and highly toxic and has the odour of rotting fish.
Toxicity
Phosphine acts on the central nervous system and the blood.
Symptoms
The symptoms exhibited by phosphine poisoning are an oppressed feeling in the chest,
headache, vertigo, general debility, loss of appetite and great thirst. Concentrations
of 2,000 ppm for a few minutes and 400 to 600 ppm are dangerous to life. 0.3 ppm is the
maximum concentration tolerable for several hours without symptoms.
No long-term exposures to this gas shall be permitted.