10 Marking and Identification
Clasification Society 2024 - Version 9.40
Statutory Documents - IMO Publications and Documents - Resolutions - Maritime Safety Committee - Resolution MSC.95(72) – Performance Standards for Daylight Signalling Lamps – (Adopted on 22 May 2000) - Annex – Recommendation on Performance Standards for Daylight Signalling Lamps - 10 Marking and Identification

10 Marking and Identification

  10.1 Daylight signalling lamps should be marked clearly and durably with the following data:

  • .1 identification of the manufacturer;

  • .2 equipment type number or model identification under which it was type tested; and

  • .3 serial number of the unit.

  10.2 On the illuminant, the manufacturer's label and the voltage and power consumption should be marked clearly and durably.

  10.3 Daylight signalling lamps should further be marked to meet the requirements of resolution A.694(17) and the applicable international standards.footnote

Parent topic: Annex – Recommendation on Performance Standards for Daylight Signalling Lamps
Copyright 2022 Clasifications Register Group Limited, International Maritime Organization, International Labour Organization or Maritime and Coastguard Agency. All rights reserved. Clasifications Register Group Limited, its affiliates and subsidiaries and their respective officers, employees or agents are, individually and collectively, referred to in this clause as 'Clasifications Register'. Clasifications Register assumes no responsibility and shall not be liable to any person for any loss, damage or expense caused by reliance on the information or advice in this document or howsoever provided, unless that person has signed a contract with the relevant Clasifications Register entity for the provision of this information or advice and in that case any responsibility or liability is exclusively on the terms and conditions set out in that contract.