4.15 Resistance to heat (see 5.14 ) [6.15]
Clasification Society 2024 - Version 9.40
Statutory Documents - IMO Publications and Documents - Resolutions - Assembly - IMO Resolution A.800(19) – Revised Guidelines for Approval of Sprinkler Systems Equivalent to that Referred to in SOLAS Regulation II-2/12 – (Adopted on 23 November 1995) - Appendix 1 - Component Manufacturing Standards for Water Mist Nozzles - 4 Water Mist Nozzle Requirements - 4.15 Resistance to heat (see 5.14) [6.15]

4.15 Resistance to heat (see 5.14 ) [6.15]

 Open nozzles should be sufficiently resistant to high temperatures when tested in accordance with 5.14. After exposure, the nozzle should not show:

  • .1 visual breakage or deformation,

  • .2 a change in flow constant K of more than 5%, and

  • .3 no changes in the discharge characteristics of the water distribution test (see 4.4.2) exceeding 5%.

Parent topic: 4 Water Mist Nozzle Requirements
Copyright 2022 Clasifications Register Group Limited, International Maritime Organization, International Labour Organization or Maritime and Coastguard Agency. All rights reserved. Clasifications Register Group Limited, its affiliates and subsidiaries and their respective officers, employees or agents are, individually and collectively, referred to in this clause as 'Clasifications Register'. Clasifications Register assumes no responsibility and shall not be liable to any person for any loss, damage or expense caused by reliance on the information or advice in this document or howsoever provided, unless that person has signed a contract with the relevant Clasifications Register entity for the provision of this information or advice and in that case any responsibility or liability is exclusively on the terms and conditions set out in that contract.