Clasification Society Rulefinder 2020 - Version 9.33 - Fix
Statutory Documents - IMO Publications and Documents - International Codes - IMSBC Code – International Maritime Solid Bulk Cargoes Code – Resolution MSC.268(85) - Section 5 – Trimming procedures - 5.4 Special provisions for non-cohesive bulk cargoes - 5.4.4 Non-cohesive bulk cargoes having an angle of repose greater than 30° to 35° inclusive

5.4.4 Non-cohesive bulk cargoes having an angle of repose greater than 30° to 35° inclusive

 These cargoes shall be trimmed according to the following criteria:

  • .1 the unevenness of the cargo surface measured as the vertical distance (Δh) between the highest and lowest levels of the cargo surface shall not exceed B/10, where B is the beam of the ship in metres, with a maximum allowable Δh = 1.5 m; or

  • .2 loading is carried out using trimming equipment approved by the competent authority.

Parent topic: 5.4 Special provisions for non-cohesive bulk cargoes
Copyright 2020 Clasification Society, International Maritime Organization, International Labour Organization or Maritime and Coastguard Agency. All rights reserved. Clasification Society, its affiliates and subsidiaries and their respective officers, employees or agents are, individually and collectively, referred to in this clause as 'Clasification Society'. Clasification Society Register assumes no responsibility and shall not be liable to any person for any loss, damage or expense caused by reliance on the information or advice in this document or howsoever provided, unless that person has signed a contract with the relevant Clasification Society entity for the provision of this information or advice and in that case any responsibility or liability is exclusively on the terms and conditions set out in that contract.