5.17 Offset Measurement of Range and Bearing
Clasification Society 2024 - Version 9.40
Statutory Documents - IMO Publications and Documents - Resolutions - Maritime Safety Committee - Resolution MSC.192(79) - Adoption of the Revised Performance Standards for Radar Equipment - (Adopted on 6 December 2004) - Annex - Revised Recommendation on Performance Standards for Radar Equipment - 5 Operational Requirements for the Radar System - 5.17 Offset Measurement of Range and Bearing

5.17 Offset Measurement of Range and Bearing

 There should be a means to measure the range and bearing of one position on the display relative to any other position within the operational display area.

Parent topic: 5 Operational Requirements for the Radar System
Copyright 2022 Clasifications Register Group Limited, International Maritime Organization, International Labour Organization or Maritime and Coastguard Agency. All rights reserved. Clasifications Register Group Limited, its affiliates and subsidiaries and their respective officers, employees or agents are, individually and collectively, referred to in this clause as 'Clasifications Register'. Clasifications Register assumes no responsibility and shall not be liable to any person for any loss, damage or expense caused by reliance on the information or advice in this document or howsoever provided, unless that person has signed a contract with the relevant Clasifications Register entity for the provision of this information or advice and in that case any responsibility or liability is exclusively on the terms and conditions set out in that contract.