2 Extent of measurement
Clasification Society 2024 - Version 9.40
Statutory Documents - IMO Publications and Documents - Resolutions - Marine Environment Protection Committee - Resolution MEPC.147(54) – Guidelines on the Assessment of Residual Fillet Weld Between Deck Plating and Longitudinals – (Adopted on 24 March 2006) - Annex – Guidelines on the Assessment of Residual Fillet Weld Between Deck Plating and Longitudinals - 2 Extent of measurement

2 Extent of measurement

 Thickness measurement on deck should be carried out according to paragraph 3 of these guidelines i.e. in every other deck longitudinal for three transverse sections, within the cargo area, as given in Table 7.3.3, paragraph 1.2, of the Condition Assessment Scheme (resolution MEPC.94(46), as amended). For areas in tanks where environmental conditions seem to be similar, the extent of this thickness measurement may be specially considered by the attending surveyor.

Parent topic: Annex – Guidelines on the Assessment of Residual Fillet Weld Between Deck Plating and Longitudinals
Copyright 2022 Clasifications Register Group Limited, International Maritime Organization, International Labour Organization or Maritime and Coastguard Agency. All rights reserved. Clasifications Register Group Limited, its affiliates and subsidiaries and their respective officers, employees or agents are, individually and collectively, referred to in this clause as 'Clasifications Register'. Clasifications Register assumes no responsibility and shall not be liable to any person for any loss, damage or expense caused by reliance on the information or advice in this document or howsoever provided, unless that person has signed a contract with the relevant Clasifications Register entity for the provision of this information or advice and in that case any responsibility or liability is exclusively on the terms and conditions set out in that contract.