Clasification Society Rulefinder 2016 - Version 9.25
Statutory Documents - IMO Publications and Documents - Resolutions - Marine Environment Protection Committee - Resolution MEPC.198(62) – 2011 Guidelines Addressing Additional Aspects to the Nox Technical Code 2008 with regard to Particular Requirements related to Marine Diesel Engines fitted with Selective Catalytic Reduction (SCR) Systems – (Adopted on 15 July 2011) - Annex – 2011 Guidelines Addressing Additional Aspects to the Nox Technical Code 2008 with regard to Particular Requirements related to Marine Diesel Engines fitted with Selective Catalytic Reduction (SCR) Systems - 6 Test Procedures for Scheme B - 6.2 Verification test procedures for an engine

6.2 Verification test procedures for an engine

  6.2.1 The purpose of the test of an engine is to establish the emission values for use in section 6.4 of these guidelines. These measurements should be in accordance with chapter 5 of the NTC 2008.

  6.2.2 Paragraph 5.9.8.1 of the NTC 2008 requires engine conditions to be measured at each mode point, for an engine system. This equally applies in the case of an engine fitted with SCR. Additionally, exhaust gas temperature at the intended inlet of the SCR chamber should be determined and recorded in the test report as required by section 5.10 of the NTC 2008.


Copyright 2016 Clasification Society, International Maritime Organization, International Labour Organization or Maritime and Coastguard Agency. All rights reserved. Clasification Society, its affiliates and subsidiaries and their respective officers, employees or agents are, individually and collectively, referred to in this clause as 'Clasification Society'. Clasification Society Register assumes no responsibility and shall not be liable to any person for any loss, damage or expense caused by reliance on the information or advice in this document or howsoever provided, unless that person has signed a contract with the relevant Clasification Society entity for the provision of this information or advice and in that case any responsibility or liability is exclusively on the terms and conditions set out in that contract.