8 Minimum net thickness of side shell plating
Clasification Society 2024 - Version 9.40
Statutory Documents - IMO Publications and Documents - Resolutions - Maritime Safety Committee - Resolution MSC.168(79) - Standards and Criteria for Side Structures of Bulk Carriers of Single-Side Skin Construction - (Adopted on 9 December 2004) - Annex 1 - Standards for Side Structures in Single-Side Skin Bulk Carriers - 8 Minimum net thickness of side shell plating

8 Minimum net thickness of side shell plating

 The thickness of side shell plating located between the hopper and top-side tank shall not be less than tp,min, in mm, given by:

Figure 1

Figure 2

Figure 3

Figure 4 Tripping brackets to be fitted in way of foremost hold

Parent topic: Annex 1 - Standards for Side Structures in Single-Side Skin Bulk Carriers
Copyright 2022 Clasifications Register Group Limited, International Maritime Organization, International Labour Organization or Maritime and Coastguard Agency. All rights reserved. Clasifications Register Group Limited, its affiliates and subsidiaries and their respective officers, employees or agents are, individually and collectively, referred to in this clause as 'Clasifications Register'. Clasifications Register assumes no responsibility and shall not be liable to any person for any loss, damage or expense caused by reliance on the information or advice in this document or howsoever provided, unless that person has signed a contract with the relevant Clasifications Register entity for the provision of this information or advice and in that case any responsibility or liability is exclusively on the terms and conditions set out in that contract.