3.2 Criteria
Clasification Society 2024 - Version 9.40
Statutory Documents - IMO Publications and Documents - Resolutions - Marine Environment Protection Committee - Resolution MEPC.147(54) – Guidelines on the Assessment of Residual Fillet Weld Between Deck Plating and Longitudinals – (Adopted on 24 March 2006) - Annex – Guidelines on the Assessment of Residual Fillet Weld Between Deck Plating and Longitudinals - 3 Local thickness measurement and criteria - 3.2 Criteria

3.2 Criteria

 When the estimated residual throat thickness is zero or less than zero, repair or renewal of the weld should be considered also based on the result of the close-up survey.

Figure 1 Thickness measurement at deck plate from upper side

Parent topic: 3 Local thickness measurement and criteria
Copyright 2022 Clasifications Register Group Limited, International Maritime Organization, International Labour Organization or Maritime and Coastguard Agency. All rights reserved. Clasifications Register Group Limited, its affiliates and subsidiaries and their respective officers, employees or agents are, individually and collectively, referred to in this clause as 'Clasifications Register'. Clasifications Register assumes no responsibility and shall not be liable to any person for any loss, damage or expense caused by reliance on the information or advice in this document or howsoever provided, unless that person has signed a contract with the relevant Clasifications Register entity for the provision of this information or advice and in that case any responsibility or liability is exclusively on the terms and conditions set out in that contract.