Section 2 Works approval process and documents
Clasification Society 2024 - Version 9.40
Clasifications Register Guidance Information - Guidance for Approval, Manufacture, Testing and Certification of High Manganese Austenitic Steel for Low Temperature Service, July 2022 - Chapter 3 Approval of a Works for the Manufacture of High Manganese Austenitic Steels - Section 2 Works approval process and documents

Section 2 Works approval process and documents

Parent topic: Chapter 3 Approval of a Works for the Manufacture of High Manganese Austenitic Steels

2.1 Process and documents to be submitted

2.1.1 The process and documents to be submitted for approval of a works for the manufacture of high manganese austenitic steels are to comply with the requirements of MQPS Book C (Procedures for Approval of a Works for Steelmaking and Rolled Steel Products), Chapter 1, Section 1 to 4 and Chapter 2, Section 1 to 4.

Copyright 2022 Clasifications Register Group Limited, International Maritime Organization, International Labour Organization or Maritime and Coastguard Agency. All rights reserved. Clasifications Register Group Limited, its affiliates and subsidiaries and their respective officers, employees or agents are, individually and collectively, referred to in this clause as 'Clasifications Register'. Clasifications Register assumes no responsibility and shall not be liable to any person for any loss, damage or expense caused by reliance on the information or advice in this document or howsoever provided, unless that person has signed a contract with the relevant Clasifications Register entity for the provision of this information or advice and in that case any responsibility or liability is exclusively on the terms and conditions set out in that contract.