1.2 Analyser specifications
Clasification Society 2024 - Version 9.40
Statutory Documents - IMO Publications and Documents - Resolutions - Marine Environment Protection Committee - Resolution MEPC.103(49) - Guidelines for On-Board NOx Verification Procedure - Direct Measurement and Monitoring Method - (adopted on 18 July 2003) - Annex - Guidelines for On-Board NOx Verification Procedure - Direct Measurement and Monitoring Method - 1 Analysing Equipment - 1.2 Analyser specifications

1.2 Analyser specifications

  1.2.1 The analyser specifications should be consistent with the NOx Technical Code, appendix 3, paragraphs 1.4, 1.5, 1.6, 1.7, 1.8 and 1.9.

  1.2.2 The analyser range should be such that the measured emission value is within 15%-100% of the range used.

  1.2.3 The analysing equipment should be installed and maintained in accordance with manufacturer's recommendations such that the requirements of the NOx Technical Code, appendix 3, paragraphs 1.5, 1.6, 1.7, 1.8, 1.9 and appendix 4, paragraphs 7 and 8, are met.

Parent topic: 1 Analysing Equipment
Copyright 2022 Clasifications Register Group Limited, International Maritime Organization, International Labour Organization or Maritime and Coastguard Agency. All rights reserved. Clasifications Register Group Limited, its affiliates and subsidiaries and their respective officers, employees or agents are, individually and collectively, referred to in this clause as 'Clasifications Register'. Clasifications Register assumes no responsibility and shall not be liable to any person for any loss, damage or expense caused by reliance on the information or advice in this document or howsoever provided, unless that person has signed a contract with the relevant Clasifications Register entity for the provision of this information or advice and in that case any responsibility or liability is exclusively on the terms and conditions set out in that contract.