Statutory Documents - IMO Publications and Documents - Resolutions - Marine Environment Protection Committee - Resolution MEPC.197(62) – 2011 Guidelines for the Development of the Inventory of Hazardous Materials – (Adopted on 15 July 2011) - Annex – 2011 Guidelines for the Development of the Inventory of Hazardous Materials - 6 Material Declaration - 6.2 Information required in the declaration
6.2 Information required in the declaration
At a minimum the following information is required in the Material Declaration:
-
.1 date of declaration;
-
.2 Material Declaration identification number;
-
.3 supplier's name;
-
.4 product name (common product name or name used by manufacturer);
-
.5 product number (for identification by manufacturer);
-
.6 declaration of whether or not the materials listed in Table A and Table B of appendix 1 of these Guidelines are present in the product above the threshold level stipulated in appendix 1 of these Guidelines; and
-
.7 mass of each constituent material listed in Table A and/or Table B of appendix 1 of these Guidelines if present above threshold level.
An example of a Material Declaration is shown in appendix 6.
| Copyright 2016 Clasification Society, International Maritime Organization, International Labour Organization or Maritime and Coastguard Agency. All rights reserved. Clasification Society, its affiliates and subsidiaries and their respective officers, employees or agents are, individually and collectively, referred to in this clause as 'Clasification Society'. Clasification Society Register assumes no responsibility and shall not be liable to any person for any loss, damage or expense caused by reliance on the information or advice in this document or howsoever provided, unless that person has signed a contract with the relevant Clasification Society entity for the provision of this information or advice and in that case any responsibility or liability is exclusively on the terms and conditions set out in that contract. |  |