Statutory Documents - IMO Publications and Documents - Resolutions - Marine Environment Protection Committee - Resolution MEPC.214(63) – 2012 Guidelines on Survey and Certification of the Energy Efficiency Design Index (EEDI) – (Adopted on 2 March 2012)Amended by Resolution MEPC.234(65) - Annex – 2012 Guidelines on Survey and Certification of the Energy Efficiency Design Index (EEDI) - Appendix 2 – Guidelines for Validation of Electric Power Tables for EEDI (EPT-EEDI) - 3 Definitions
3 Definitions
3.1 Applicant means an organization, primarily a shipbuilder or a ship designer, which requests the EPT-EEDI validation in accordance with these Guidelines.
3.2 Validator means a Recognized Organization which conducts the EPT-EEDI validation in accordance with these Guidelines.
3.3 Validation for the purpose of these Guidelines means review of submitted documents and survey during construction and sea trials.
3.4 Standard EPT-EEDI-Form refers to the layout given in appendix 3 that contains the EPT-EEDI results that will be the subject of validation. Other supporting documents submitted for this purpose will be used as reference only and will not be subject to validation.
3.5 PAE herein is defined as per definition in paragraph 2.5.6 of the EEDI Calculation Guidelines.
3.6 Ship Service and Engine-room Loads refer to all the load groups which are needed for the hull, deck, navigation and safety services, propulsion and auxiliary engine services, engine-room ventilation and auxiliaries and ship's general services.
3.7 Diversity Factor is the ratio of the "total installed load power" and the "actual load power" for continuous loads and intermittent loads. This factor is equivalent to the product of service factors for load, duty and time.
| Copyright 2016 Clasification Society, International Maritime Organization, International Labour Organization or Maritime and Coastguard Agency. All rights reserved. Clasification Society, its affiliates and subsidiaries and their respective officers, employees or agents are, individually and collectively, referred to in this clause as 'Clasification Society'. Clasification Society Register assumes no responsibility and shall not be liable to any person for any loss, damage or expense caused by reliance on the information or advice in this document or howsoever provided, unless that person has signed a contract with the relevant Clasification Society entity for the provision of this information or advice and in that case any responsibility or liability is exclusively on the terms and conditions set out in that contract. |  |