The following areas are the minimum areas that shall be
                           protected according to this Standard:
                        
                        
                        
                        
                           - 
                              
                              
                              
                                 .1 Deckhead with complete internal structure,
                                 including brackets connecting to longitudinal and transverse bulkheads.
                                 In tanks with ring frame girder construction the underdeck transverse
                                 framing to be coated down to level of the first tripping bracket below
                                 the upper faceplate.
                              
                              
                              
                            
                           - 
                              
                              
                              
                                 .2 Longitudinal and transverse bulkheads to be
                                 coated to the uppermost means of access level. The uppermost means
                                 of access and its supporting brackets to be fully coated.
                              
                              
                              
                            
                           - 
                              
                              
                              
                                 .3 On cargo tank bulkheads without an uppermost
                                 means of access the coating to extend to 10% of the tank's height
                                 at centreline but need not extend more than 3 m down from the deck.
                              
                              
                              
                            
                           - 
                              
                              
                              
                                 .4 Flat inner bottom and all structure to height
                                 of 0.3 m above inner bottom to be coated.
                              
                              
                              
                            
                        
                        
                        
                        
                        
                        
                        
                        
                        Figure 1