4.3 Strength of connections
Clasification Society 2024 - Version 9.40
Statutory Documents - IMO Publications and Documents - Resolutions - Assembly - IMO Resolution A.753(18) - Guidelines for the Application of Plastic Pipes on Ships - (adopted on 4 November 1993)Amended by Resolution MSC.313(88) - Annex - Guidelines for the Application of Plastic Pipes on Ships - 4 Installation - 4.3 Strength of connections

4.3 Strength of connections

  4.3.1 The requirements for connections are the same as those requirements for the piping system in which they are installed, as stated in paragraph 2.1.1.5.

  4.3.2 Pipes may be assembled using adhesive-bonded, flanged or mechanically coupled joints.

  4.3.3 Adhesives, when for joint assembly should be suitable for providing a permanent seal between the pipes and fittings throughout the temperature and pressure range of the intended application.

  4.3.4 Tightening of flanged or mechanically coupled joints should be performed in accordance with the manufacturer's instructions.

Parent topic: 4 Installation
Copyright 2022 Clasifications Register Group Limited, International Maritime Organization, International Labour Organization or Maritime and Coastguard Agency. All rights reserved. Clasifications Register Group Limited, its affiliates and subsidiaries and their respective officers, employees or agents are, individually and collectively, referred to in this clause as 'Clasifications Register'. Clasifications Register assumes no responsibility and shall not be liable to any person for any loss, damage or expense caused by reliance on the information or advice in this document or howsoever provided, unless that person has signed a contract with the relevant Clasifications Register entity for the provision of this information or advice and in that case any responsibility or liability is exclusively on the terms and conditions set out in that contract.