SP133
|
Insert "(Model No.1, see 5.2.2.2.2)"
after "risk label".
|
SP162
|
Delete.
|
SP181
|
Insert "(Model No.1, see 5.2.2.2.2)"
after "risk label".
|
SP204
|
Insert "(Model No.8, see 5.2.2.2.2)"
after "risk label".
|
SP215
|
In the last sentence, amend "azocarbonamide"
to read "azodicarbonamide".
|
SP216
|
In the last sentence, insert "and articles"
before "containing" and amend the end to read: "… free liquid
in the packet or article.".
|
SP247
|
Amend the end of the first paragraph
to read:
|
|
"…may be transported in wooden barrels with a capacity
of more than 250 litres and not more than 500 litres meeting the general
requirements of 4.1.1, as appropriate, on the following conditions:…".
|
|
In subparagraph .5, add at the end "or
regulation II-2/54 of SOLAS 74, as amended by the resolutions indicated
in II-2/1.2.1, as applicable".
|
|
Replace the word "casks" wherever it appears with "wooden
barrels" in the special provision.
|
SP251
|
In the first sentence, add "for example"
before "for medical," add "or repair" before "purposes". Replace "or"
between "analytical" and "testing" with ",".
|
SP282
|
Delete.
|
SP289
|
Amend as follows: Replace
"vehicles" and "vehicle" with "conveyances" and "conveyance", respectively.
|
SP292
|
Amend to read as follows:
|
|
"Mixtures containing not more than 23.5% oxygen by volume
may be transported under this entry when no other oxidizing gases
are present. A class 5.1 subsidiary risk label is not required for
any concentrations within this limit.".
|
SP293
|
Amend to read:
|
|
"The following definitions apply to matches:
|
|
(a) Fusee matches are matches the heads of which are
prepared with a friction-sensitive igniter composition and a pyrotechnic
composition which burns with little or no flame, but with intense
heat;
(b) Safety matches are combined with or attached to
the box, book or card that can be ignited by friction only on a prepared
surface;
(c) Strike anywhere matches are matches that can be
ignited by friction on a solid surface;
(d) Wax Vesta matches are matches that can be ignited
by friction either on a prepared surface or on a solid surface.".
|
SP297
|
In the first paragraph, amend "5.4.2.1.9"
to read "5.4.2.1.8".
|
SP298
|
Delete.
|
SP299
|
In paragraph (iii), replace "620" with
"360".
|
SP303
|
Amend to read as follows:
|
|
"Receptacles shall be assigned to the class and, if any,
subsidiary hazard of the gas or mixture of gases contained therein
determined in accordance with the provisions of chapter 2.2.".
|
SP309
|
Amend to read as follows:
|
|
"This entry applies to non sensitized emulsions, suspensions
and gels consisting primarily of a mixture of ammonium nitrate and
fuel, intended to produce a Type E blasting explosive only after further
processing prior to use.
|
|
The mixture for emulsions typically has the following composition:
60-85% ammonium nitrate, 5-30% water, 2-8% fuel, 0.5-4% emulsifier
agent, 0-10% soluble flame suppressants, and trace additives. Other
inorganic nitrate salts may replace part of the ammonium nitrate.
|
|
The mixture for suspensions and gels typically has the
following composition: 60-85% ammonium nitrate, 0-5% sodium or potassium
perchlorate, 0-17% hexamine nitrate or monomethylamine nitrate, 5-30%
water, 2-15% fuel, 0.5-4% thickening agent, 0-10% soluble flame suppressants,
and trace additives. Other inorganic nitrate salts may replace part
of the ammonium nitrate.
|
|
Substances shall satisfactorily pass Test Series 8 of the
United Nations Manual of Tests and Criteria, Part I, Section 18 and
be approved by the competent authority.".
|
SP313
|
Insert "(Model No.8, see 5.2.2.2.2)"
after "risk label".
|
SP316
|
Delete "or hydrated".
|
SP319
|
Delete
the first sentence.
|
SP320
|
Delete.
|