6.3.5 Sampling for gaseous emissions
Clasification Society 2024 - Version 9.40
Statutory Documents - IMO Publications and Documents - International Codes - NOx Technical Code - Technical Code on Control of Emission of Nitrous Oxides from Marine Diesel Engines - Chapter 6 - Procedures for demonstrating compliance with NOx emission limits on board - 6.3 Simplified measurement method - 6.3.5 Sampling for gaseous emissions

6.3.5 Sampling for gaseous emissions

  6.3.5.1 The general requirements described in 5.9.3 shall be applied for on-board measurements as well.

  6.3.5.2 The installation on board of all engines shall be such that these tests may be performed safely and with minimal interference to the engine. Adequate arrangements for the sampling of the exhaust gas and the ability to obtain the required data shall be provided on board a ship. The uptakes of all engines shall be fitted with an accessible standard sampling point.

Parent topic: 6.3 Simplified measurement method
Copyright 2022 Clasifications Register Group Limited, International Maritime Organization, International Labour Organization or Maritime and Coastguard Agency. All rights reserved. Clasifications Register Group Limited, its affiliates and subsidiaries and their respective officers, employees or agents are, individually and collectively, referred to in this clause as 'Clasifications Register'. Clasifications Register assumes no responsibility and shall not be liable to any person for any loss, damage or expense caused by reliance on the information or advice in this document or howsoever provided, unless that person has signed a contract with the relevant Clasifications Register entity for the provision of this information or advice and in that case any responsibility or liability is exclusively on the terms and conditions set out in that contract.