7 Test Report
Clasification Society 2024 - Version 9.40
Statutory Documents - IMO Publications and Documents - Resolutions - Maritime Safety Committee - Resolution MSC.41(64) - Interim Standard for Measuring Smoke and Toxic Products for Combustion - (adopted on 5 December 1994) - Annex - Interim Standard for Measuring Smoke and Toxic Products of Combustion - 7 Test Report

7 Test Report

 A test report should contain the following information:

  • .1 type of the material, i.e. surface finish, floor covering, primary deck covering, pipes, etc;

  • .2 trade name of the material;

  • .3 description of the material;

  • .4 construction of the specimen;

  • .5 name and address of the manufacturer of the material;

  • .6 Dm at each heating and ignition condition;

  • .7 concentrations of toxic gases in ppm, if applicable;

  • .8 judgement according to 6;

  • .9 name and address of the testing laboratory; and

  • .10 date of testing

Parent topic: Annex - Interim Standard for Measuring Smoke and Toxic Products of Combustion
Copyright 2022 Clasifications Register Group Limited, International Maritime Organization, International Labour Organization or Maritime and Coastguard Agency. All rights reserved. Clasifications Register Group Limited, its affiliates and subsidiaries and their respective officers, employees or agents are, individually and collectively, referred to in this clause as 'Clasifications Register'. Clasifications Register assumes no responsibility and shall not be liable to any person for any loss, damage or expense caused by reliance on the information or advice in this document or howsoever provided, unless that person has signed a contract with the relevant Clasifications Register entity for the provision of this information or advice and in that case any responsibility or liability is exclusively on the terms and conditions set out in that contract.