Part 3 - Documentation of Approval
Clasification Society 2024 - Version 9.40
Statutory Documents - IMO Publications and Documents - Resolutions - Marine Environment Protection Committee - Resolution MEPC.108(49) - Revised Guidelines and Specifications for Oil Discharge Monitoring and Control Systems for Oil Tankers - (Adopted on 18 July 2003)Amended by Resolution MEPC.240(65) - Annex - Revised Guidelines and Specifications for Oil Discharge Monitoring and Control Systems for Oil Tankers - Annex - Part 3 - Documentation of Approval

Part 3 - Documentation of Approval

Parent topic: Annex

3.1 Certificate of type approval for oil content meters

  3.1.1 Satisfactory compliance with all the test requirements enumerated in part 1 of this annex should be shown in the certificate of type approval issued by the Administration in the format specified in paragraph 3.1.2 below. An Administration may issue a certificate of type approval based on separate testing or on testing already carried out under supervision by another Administration.

  3.1.2 A certificate of type approval should be in the format shown in the appendix to this annex. The certificate should identify the type and model of the oil content meter to which it applies and identify equipment assembly drawings, duly dated. Each drawing should bear the model specification numbers or equivalent identification details. The certificate should include the full performance test protocol on which it is based. If a certificate of type approval is issued by an Administration based on a certificate previously issued by another Administration, the certificate should identify the Administration which conducted the tests on the oil content meter and a copy of the original test should be attached to it.

3.2 Format of environmental test protocol

  3.2.1 Satisfactory compliance with the environmental tests laid down in these Guidelines and Specifications, where applicable, should be shown on the environmental test protocol issued by the testing laboratory. The protocol should include at least the following details:

  • .1 identification of the equipment by type and drawing number, duly dated; and

  • .2 a statement of the tests conducted on the equipment, including the results thereof.

  3.2.2 The environmental test protocol should be endorsed by either the Administration or a competent authority of the manufacturer's home country to confirm that the laboratory is approved to conduct such tests. The protocol should also be signed and dated by the person in charge of the laboratory.

Copyright 2022 Clasifications Register Group Limited, International Maritime Organization, International Labour Organization or Maritime and Coastguard Agency. All rights reserved. Clasifications Register Group Limited, its affiliates and subsidiaries and their respective officers, employees or agents are, individually and collectively, referred to in this clause as 'Clasifications Register'. Clasifications Register assumes no responsibility and shall not be liable to any person for any loss, damage or expense caused by reliance on the information or advice in this document or howsoever provided, unless that person has signed a contract with the relevant Clasifications Register entity for the provision of this information or advice and in that case any responsibility or liability is exclusively on the terms and conditions set out in that contract.