Section 3 Bending moment applied
Clasification Society 2024 - Version 9.40
Clasifications Register Guidance Information - Guidance Notes for the Classification of Special Service Craft – Calculation Procedures for Composite Construction, July 2013 - Chapter 4 Design of Sandwich Panel Laminates - Section 3 Bending moment applied

Section 3 Bending moment applied

3.1 The bending moment to be applied at 1 cm width of the sandwich panel is given by Pt 8, Ch 3, Pt 8, Ch 3, 1 General of the Rules for Special Service Craft. In this example it is evident that the maximum bending moment and hence maximum stress occurs under the base of the stiffener. Due to the high aspect ratio no correction factor needs to be applied to modify the applied bending moment.

Parent topic: Chapter 4 Design of Sandwich Panel Laminates
Copyright 2022 Clasifications Register Group Limited, International Maritime Organization, International Labour Organization or Maritime and Coastguard Agency. All rights reserved. Clasifications Register Group Limited, its affiliates and subsidiaries and their respective officers, employees or agents are, individually and collectively, referred to in this clause as 'Clasifications Register'. Clasifications Register assumes no responsibility and shall not be liable to any person for any loss, damage or expense caused by reliance on the information or advice in this document or howsoever provided, unless that person has signed a contract with the relevant Clasifications Register entity for the provision of this information or advice and in that case any responsibility or liability is exclusively on the terms and conditions set out in that contract.