13.2 Transverse divisions
Clasification Society 2024 - Version 9.40
Statutory Documents - IMO Publications and Documents - International Codes - Grain Code - International Code for the Safe Carriage of Grain in Bulk – Resolution MSC.23(59) - Part A - Specific requirements - 13 Divisions loaded on one side only - 13.2 Transverse divisions

13.2 Transverse divisions

 The load (P) in kilonewtons per metre length of the divisions shall be taken as follows:

  • .1 Table A 13-3

  • .2 Intermediate values of L and intermediate values of h when h is equal to or less than 6.0 m may be determined by linear interpolation using table A 13-3.

  • .3 For values of h exceeding 6.0 m the load (P) in kilonewtons per metre length of the divisions may be determined from table A 13-4 by entering with the ratio L/h and utilizing the formula:

  • .4 Table A 13-4

Parent topic: 13 Divisions loaded on one side only
Copyright 2022 Clasifications Register Group Limited, International Maritime Organization, International Labour Organization or Maritime and Coastguard Agency. All rights reserved. Clasifications Register Group Limited, its affiliates and subsidiaries and their respective officers, employees or agents are, individually and collectively, referred to in this clause as 'Clasifications Register'. Clasifications Register assumes no responsibility and shall not be liable to any person for any loss, damage or expense caused by reliance on the information or advice in this document or howsoever provided, unless that person has signed a contract with the relevant Clasifications Register entity for the provision of this information or advice and in that case any responsibility or liability is exclusively on the terms and conditions set out in that contract.